Insight

One atomic statement made by an expert, a student or a publication, with its evidence status.

Expert Open for expert review · What do these labels mean?

Counterintuitively, the worst thing to print is a small column: each layer takes so little time that material stacks up before it can gain strength. Prvok used a nozzle roughly 4 cm in diameter with a layer height of about 12 mm; reducing layer height to chase resolution can add around three extra hours of printing.

— Paraphrased from the lecture

Where in the source~45:55 and ~1:04:19 — anchor: “The worst object to print actually is a very small column”
Confidencehigh

Context

In the Q&A Vele (CTU Prague / Scoolpt) first notes that lowering the layer height for resolution makes printing much longer. Later, answering a question on layer height and nozzle size that is not captured in the transcript, he gives the settings used for Prvok and explains why small objects are the hardest to print.

From the transcript

And the lower layer height is, the longer it takes to print. So just by like lowering down the layer [height], you can like reach up to like three extra hours of printing, or I think like unreasonable. — (Q&A) Most of the times, or the [Prvok], was printed with nozzle diameter of something like 4 centimeters and the layer height was about 12mm. […] The worst object to print actually is very small column, because the print time of one layer is very short and you stick a lot of material on top of each other. So it’s kind of contradictory. But the bigger object you print, the [easier it] gets printed, because you have more time to print. And the concrete can gain the strength to survive the next layer and then gain another strength to survive in the next layer.

Automatic transcript, Q&A, 00:45:51, and Q&A, 01:04:19. Lightly cleaned: repeated words and fillers removed, omissions marked […], editorial insertions in [brackets].

Connections


Something wrong or missing? Suggest a correction